Filter
Top Products
5
RY PACK
one telephone jack (RJ 14),
insert one end of the four
wire (black tipped) tel-
ephone line cord into the
jack marked L1/L2 at the
rear of the Base Unit. Plug
the other end into the
telephone wall jack. If your
two telephone lines are each
serviced by a separate
telephone jack (RJ 11),
insert one end of a tel-
ephone line cord into the
jack marked L1/L2 (this will be your Line
1) and a second telephone cord into the
jack marked L2 (this will be your Line 2)
at the rear of the Base Unit. Plug the other
end of the telephone cords into the ap-
propriate wall jacks. Make sure the plugs
snap securely into place.
6. CHECK FOR A DIAL TONE. After the
battery pack is charged, raise the Base
Unit Antenna to an upright position. Then,
pick up the Handset and press a LINE key.
The corresponding LINE LED (on the
Base Unit) and the LINE key (on the
Handset) will glow red, and you should
hear a dial tone. If not, see IN CASE OF
DIFFICULTY.
CAUTION:
1. Never install telephone wiring during a
lightning storm.
2. Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
3. Never touch uninsulated telephone wires
or terminals unless the telephone line has
been disconnected at the network
interface.
4. Use caution when installing or modifying
telephone lines.
TELEPHONE
WALL JACK
AC ELECTRICAL
OUTLET
OR
OR
PLUSE TONE
9V DC L1 or L1/L2
L2
TEL LINE
GETTING STARTED
SETTING UP YOUR
VTECH 921 ADL
1. Choose an area near an electrical outlet
and a telephone wall jack.
2. Plug the AC power adaptor into an
electrical outlet and the DC connector to
the back of the Base Unit.
CAUTION: Use Class 2 Power
Source Only. Use only the AC
adaptor shipped with your
921
ADL
. This is a Class 2 AC adap-
tor, specifically designed for use
with the
921 ADL
.
NOTE: Connect power to the Base Unit
before placing the Handset in the cradle.
3. Set the TONE/PULSE switch on the Base
Unit. If you have touch tone service on
your phone line, set the switch to TONE.
If you have rotary service, set the switch
to PULSE.
4. CHARGE THE HANDSET BATTERY
PACK BEFORE USE. The battery pack
recharges automatically whenever the
Handset is in the Base Unit cradle. The
battery pack should be charged for 16
hours before using your phone for the first
time.
5. Connect the telephone line cord(s). If
you have two lines which are serviced by