Filter
Top Products
14
This equipment complies with Parts 15 and 68 of
the Federal Communications Commission (FCC)
rules for the United States.
A label is located on the underside of the base unit
containing either the FCC registration number and
Ringer Equivalence Number (REN) or the IC regis-
tration number and Load Number (LN). You must,
upon request, provide this information to your local
telephone company.
This equipment is compatible with inductively
coupled hearing aids.
Should you experience trouble with this telephone
equipment, please coXntact:
In the United States:
VTECH COMMUNICATIONS
1-800-595-9511
In Canada:
VTECH ELECTRONICS
1-800-267-7377
for repair/warranty information. The telephone com-
pany may ask you to disconnect this equipment
from the line network until the problem has been
corrected.
Your
VTech 921 ADL
is designed to operate at the
maximum power allowed by the FCC and IC. This
means your handset and base unit can communi-
cate only over a certain distance - which will
depend on the location of the base unit and hand-
set, weather, and the construction and layout of your
home or office.
FCC Part 15
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance's could void the user's authority to
operate the equipment.
The equipment has been tested and found to
comply with part 15 of the FCC rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential instal-
lation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communica-
tions. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If
this equipment does cause harmful interference to
radio or television reception, which can be deter-
mined by turning the equipment off and on, the user
is encouraged to try and correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet or on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
FCC Part 68
The FCC requires that you connect your cordless
telephone to the nationwide telephone network
through a modular telephone jack (USOC RJ11C
or RJ11W ).
Your telephone company may discontinue your
service if your equipment causes harm to the tel-
ephone network. They will notify you in advance of
disconnection, if possible. During notification, you
will be informed of your right to file a complaint with
the FCC.
Occasionally, your telephone company may make
changes in its facilities, equipment, operation, or
procedures that could affect the operation of your
equipment. If so, you will be given advance notice
of the change to give you an opportunity to main-
tain uninterrupted service.
The base unit contains no user serviceable parts.
The handset contains a user replaceable battery
pack.
If it is determined that your telephone equipment is
malfunctioning, the FCC requires that it not be used
and that it be unplugged from the modular jack until
the problem has been corrected. Repairs to this
telephone equipment can only be made by the
manufacturer or its authorized agents or by others
who may be authorized by the FCC. For repair pro-
cedures, follow the instructions outlined under the
VTECH Limited Warranty.
This equipment may not be used on coin service
lines provided by the phone company or on party
lines.
The REN is useful in determining the number of
devices you may connect to your telephone line
and still enable the devices to ring when you re-
ceive a call. The general rule is that the REN value
should not exceed 5.0A total; however, contact your
local telephone company for the specific number
in your area.
FCC & IC REGULATIONS