Filter
Top Products
27
YOU HEAR NOISE IN THE HAND-
SET, AND NONE OF THE KEYS OR
BUTTONS WORK.
• Make sure the power cord is plugged
in.
• Your base unit and handset may not
be operating on the same channel
or security code. Place the handset
in the cradle for a few moments to
reload the security code and reset
the channel.
COMMON CURE FOR ELECTRONIC
EQUIPMENT
Electronics, like people, can
sometimes get confused. If the unit
does not seem to be responding
normally, then try putting the handset
in the cradle to re-initialize the unit. If
it still does not seem to respond,
perform the following steps (in the order
listed):
1. Disconnect the power to the base.
2. Disconnect the handset battery.
3. Wait a few minutes.
4. Connect power to the base.
5. Connect the handset battery.
6. Put the handset in the base to re-
initialize.
IN CASE OF DIFFICULTY