Filter
Top Products
14
IMPORTANT: Whenever the handset
batteries are removed, the handset
must be reinitialized on the base unit
cradle after the batteries are replaced.
The In Use LED on the base unit will
flash during the initialization.
Making Calls
Pick up the handset and press
PHONE. When you hear a dial tone,
dial the number. The indicator for IN
USE (on the base unit) and IN USE (on
the handset) will light.
If you make a mistake when dialing,
press OFF to hang up, then press
PHONE to get the dial tone again.
You must always press PHONE before
you can dial a call on the handset.
Answering Calls
When an incoming call is ringing, the IN
USE LED in the base and the IN USE
LED in the handset will flash. To make
sure your phone rings when the handset
is away from the base, please keep the
base antenna in the upright position.
To answer a call when the handset is
in the base, just pick up the handset.
and
MAKING CALL
ANSWERING CALL
TONE
PROG
*
MEM
OPER
0
REDIAL
#
LOW
6
9
3
BATT
PHONE
1
7
PRS
4
GHI
ABC
2
JKL
TUV
8
5
CHAN
900
IN USE
MHz CORDLESS
DEF
WXY
MNO
OFF
To answer a call when the handset is
away from the base, just press any key
on the handset (except OFF). This is
very useful in a dark environment; you
do not have to fumble around looking
for the PHONE key to answer the call.
Disconnecting
To end a call, either place the handset
back in the base, or press OFF on the
handset.
Changing Channels
If you notice interference when using
your handset, press CHAN to switch
to a clear channel. This function is only
available when you are on a call.
900
MHz CORDLESS
IN USE
LOW
BATT
PHONE
CHAN
OFF
2
ABC
1
DEF
3
4
GHI JKL
5
MNO
6
PRS
7
TUV
8
WXY
9
TONE
*
0
OPER
#
MEM
PROG REDIAL
TO END THE CALL
900
MHz CORDLESS
IN USE
LOW
BATT
PHONE
CHAN
OFF
2
ABC
1
DEF
3
4
GHI JKL
5
MNO
6
PRS
7
TUV
8
WXY
9
TONE
*
0
OPER
#
MEM
PROG
REDIAL
CHANGING
CHANNELS
OPERATING INSTRUCTIONS