Filter
Top Products
Using the Redial Button
RDLlPdials the last number that you called. This feature is extremely useful
when the number you called is busy. To use this feature, simply press
FLASH,then RDLlP.The last number called will then be dialed again.
NOTE: If any other key is pressed before RDLlP,the phone will not redial
the last number.
Answeri ng a Call
Your XC 320 will ring when someone is calling your number. If your Handset
is not in the Base Unit, press TALKto answer the call. If your Handset is in
the Base Unit, the Auto Talkfeature allows you to answer the call by simply
lifting the Handset from the Base Unit and beginning your conversation.
Using the AutoStandby Feature
When you finish a call and place the Handset back on the Base Unit,
AutoStandbyautomatically hangs up the phone. There is no need to press
TALKto hang up.
NOTE: If you don't place the Handset back on the Base Unit, you need
to press TALKto hang up the phone.
NOTE: Sometimes whenyou press TALKto hang up the phone, you may
get an error tone and the phone will not disconnect This may
occur during conversations under noisy conditions. If this
happens, place the Handset back on the Base Unit, or press
TALKagain while holding the Handset close to the Base Unit.
Storing a Number
To store a number in memory:
1. Remove the Handset and press MEM.(Do not press TALK.)You will hear
a beep indicating the unit is ready to be programmed.
2. Enter the number (up to 16 digits) you want to store.
3. If you wish to enter a delay between numbers (for accessing a
switchboard, or long distance service), press RDLlPat the point in the
number sequence you wish to pause. (Note: TheRDLlPbutton counts as
one digit) Pressing RDLlPmore than once will increase the length of the
pause between numbers.
4. Press MEMand a number (01-20) for the memory location you wish to
use.
You will hear a long beep when the number you have entered has been
successfully stored.
17