Filter
Top Products
1) When the phone is in the standby mode, press pb/rocket/<. The handset displays the
number of the phonebook locations used, and information on searching and storing
phonebook locations.
(1st line) the number of the phonebook locations
(2nd line) How to search (the number keypad, + or -)
(3rd line) How to enter the storing operation (Press
select/ch)
2) Press
select/ch, then “Store/Edit Name” appears.
3) Store the name (up to 16 characters) by using the number keypad.
• See the “Steps for entering names and special characters” (see page 28).
• Use cid/> and pb/rocket/< to move the cursor to the desired location.
• Use
xfer/del to delete characters as needed.
• Press and hold xfer/del to delete all the characters.
If a name is not required, go to step 4.
4) Press select/ch to store the name,
then “Store/Edit No.” appears.
5) Press the number keypad to enter the phone number (up to 20
digits), then press select/ch to store the number.
PHONEBOOK [ 27]
PHONEBOOK
• If you press end or
don’t press a key
within 30 seconds
while in the storing
operation, the phone
will return to the
standby mode.
• When the memory is
full, you will hear a
beep and “
Memory
Full
” appears. You
cannot store names
and numbers.
• The pause key counts
as one digit.
Pressing
redial/p
more than once
increases the
length of pause
between numbers.
Phonebook allows you to dial a number using just a few key presses.
Your phone stores names/numbers in the phonebook memory location, and you can search
names in alphabetical order. You have a total of 100 locations that can be used for the
phonebook (including the Speed dial locations) and Caller ID messages.
Storing Phone Numbers, Names, Distinctive Rings,
and Speed Dial
If you get an incoming call, a transferring call, or page, the operation is canceled.
Phonebook
TRU4465_OM 8/2/02 10:31 AM Page 27