Filter
Top Products
GETTING STARTED [ 11]
GETTING STARTED
B. Install the battery pack
Charge the battery pack for at least 15-20 hours before
plugging the phone line into your base unit.
1) Press down on the battery cover release and slide the cover
down until it comes off.
2) Connect the battery pack connector observing the correct
polarity (black and red wires) to the jack inside the
battery compartment.
Do not exert any force on this connection. It could cause
damage to the battery or to the handset. The plastic
connectors will fit together in only one way. Once you are
certain that you have made a good connection, then insert
the battery pack into the battery compartment. Do not
pinch the wires.
3) Securely close the battery compartment cover by sliding it
up until it snaps into place.
4) Place the handset in the charging cradle with the keypad
facing forward.
• Use only the Uniden
battery (BT-446)
supplied with your
phone.
Replacement
batteries are also
available through
the Uniden Parts
Department. (See
page 9.)
• Recharge your phone
on a regular basis by
returning the handset
to the base after each
phone call.
TRU4465_OM 8/2/02 10:30 AM Page 11