Filter
Top Products
GETTING STARTED[ 10 ]
Mounting the Base Unit on a Wall
Setting the handset retainer clip for wall mounting
1 On the base unit, pull the handset retainer clip out of
the slot and rotate it clockwise 180 degrees.
2 Flip the retainer clip from front to back. Slide it back
into the slot so that the lip of the retainer is up and
the is down. The retainer holds the handset
in place.
Standard wall plate mounting
This phone can be mounted on any standard
wall plate.
1 Route the AC adapter cord inside the molded
wiring channel as shown.
2 Plug the telephone line cord into the TEL
LINE jack. Route the cord inside the molded
wiring channel as shown.
3 Raise the antenna to a vertical position.
4 Align the mounting slots on the base with the mounting posts on the
wall. Then push in and down until the phone is firmly seated.
ª
AC Adapter
Power Outlet
(AC 120V, 60Hz)
Telephone
Line Cord
Raise the
antenna.
Single-Line
Telephone Jack
(RJ11C)
Flip the hook tab over
so the tab holds the
handset.
DO NOT use an outlet
controlled by a
wall switch.
!
EXT1265 10/1/1 9:24 AM Page 10