Filter
Top Products
GETTING STARTED [ 9 ]
GETTING STARTED
D. Choose the dialing mode
Most phone systems use tone dialing, which sends DTMF tones through the
phone lines. However, some phone systems still use pulse dialing such as in
rural areas. The default setting is tone dialing. Depending on your dialing
system, set the mode as follows:
Base setting only
1 Press and hold until you hear a confirmation tone.
2 To set the dial mode for pulse dialing, press . Or to set the dial
mode for tone dialing, press . A confirmation tone sounds to
indicate the setting is complete.
• If you are not sure of your dialing system, set for tone dialing. Make a
trial call. If the call connects, leave the setting as is, otherwise set for
pulse dialing.
• If your phone system requires pulse dialing and you need to send the DTMF
tones for certain situations during a call, you may “switch-over” to tone
dialing (refer to “Tone Dialing Switch-over” on page 32).
#
call waiting
Make sure your battery
pack is fully charged
before choosing the
dial mode.
note
EXT1265 10/1/1 9:24 AM Page 9