Filter
Top Products
TROUBLESHOOTING [58]
www.uniden.com
TROUBLESHOOTING
While the UIP160P is downloading a firmware update or a new configuration file from Packet8, the LEDs will
blink several times.
Resetting the UIP160P
There are two ways to reset the UIP160P: a power cycle restarts the unit, and a hard reset restores the
unit to factory defaults.
Power Cycle
Simply unplug the telephone UIP160P and plug it in again. This restarts the UIP160P and reloads the
configuration file.
Hard Reset
A hard reset restores the UIP160P to factory defaults. All configuration changes will be lost.
A: Unplug the UIP160P's AC adapter.
B: Insert a pin or bent-out paper clip into the RESET hole on the rear of the UIP160P and push the reset
button.
C: While holding the reset button pushed in, reconnect the UIP160P's AC adapter.
D: Hold the reset button for ten seconds and then release it. This sets the UIP160P main base back to
factory defaults.
WAN
The UIP160P detects a valid link
on its WAN port.
The UIP160P cannot detect a valid link.
The UIP160P is receiving data on its
WAN port.
Phone
The telephone connected to this
port is in use or off hook.
The connected phone is on hook (not in use).
Fast: There is an incoming call.
Slow: There is a message waiting.
LED On Off Blinking