Filter
Top Products
SETTING UP THE PHONE [12]
www.uniden.com
SETTING UP THE
PHONE
Install the rechargeable battery pack into the handset
1) Press down on the handset battery case cover (use the
finger indention for a better grip) and slide the cover
downward to remove.
2) Plug the battery pack connector (red & black wires) into
the jack inside the battery compartment. (The connector
notches fit into the grooves of the jack only one way.)
Match the wire colors to the polarity label in the battery
compartment, connect the battery and listen for a click to
insure connection.
3) Make sure you have a good connection by slightly pulling
on the battery wires. If the connection is secure, the
battery jack will remain in place.
4) Place the battery case cover back on the handset and slide
it upwards until it clicks into place.
5) Place the handset in the base with the keypad facing
forward.
6) Make sure that the charge LED illuminates. If the LED does
not illuminate, check to see that the AC adapter is plugged
in and the handset makes good contact with the base
charging contacts.
7) Charge the handset battery pack for at least 15-20 hours before using your new cordless
handset for the first time.
•
Use only the Uniden (BT-
446) rechargeable battery
pack supplied with your
cordless telephone.
•
Replacement battery packs
are also available through
the Uniden Parts
Department (see back cover
page).
note