Operation
12
40 Receive Channels
The uh095sx also has 40 receive only channels (CH41 to CH80) which can be
programmed with frequencies ranging from 450-512MHz (in 12.5kHz steps). When
programmed they are added to the FM band channels.
If you know the frequency you may store it manually.
Manual Programming
Turn power off. Press and hold
while turning power back on.
The channel indicator flashes the
lowest available empty channel. You
may use the or to select
another channel.
Press /ENTER . The first digit of the frequency indicator
flashes. Press or to select first digit.
Press or to move left or right between digit positions and press or
to change digits.
When finished press /ENTER, the channel indictor flashes. Press or to
select next channel for programming or press and hold /ENTER to store setting.
A confirmation tone sounds. The channel is automatically entered into OS scan
memory.
Deleting a Programmed Receive Channel
Follow the steps in Manual Programming to enter a frequency for a desired channel.
Select 0 for the first frequency digit and then press /ENTER. Press or to
select another channel or press and hold /ENTER to exit programming
mode.
Roger Beep
Roger Beep is a BEEP that is sent to
notify the end of transmission (both
PTT and VOX transmission.)
Press eight times.
Press or to display ON.
Press and hold /ENTER to store
the new setting.
If a button is not pressed within 10 seconds the uh095sx will
automatically exit the Menu Mode.
MENU
MON
MON
MENU
MENU
SCAN
MENU
MENU
UNIDEN Model uh095sx Dual Band (UHF CB/AM CB) Radio
MENU
MENU