Filter
Top Products
CALLER ID [53]
www.uniden.com
Long Distance calls and Area Code Setting/Cancellation
While the present Caller ID information is displayed, pressing
*
/tone/< will place
or remove the prefix "1" in the display to set the call for a long distance call, or
pressing #/
> will set or cancel an area code (see page 30).
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook. The phone
number and name of the party on the Caller ID list can be stored in memory.
1) When the phone is in standby mode, select the Caller ID message to be stored.
Then press the
STORE soft key.
Store/Edit Name
appears. If the Caller ID message
is already stored in memory, you will hear a beep and
This data is already
stored!!
appears. The number will not be stored.
2) To complete the setting, follow the steps 4-8 in "Phonebook (Storing Phone
Numbers, Names, Distinctive Rings, and Speed dial)" on page 41.
•When a long distance call
has been set, "
1
" appears
in the display.
•If a call comes in via a
telephone system that
does not offer Caller ID
service, no information is
stored.
•If the Caller ID message
was received as a private/
unknown number, or the
message does not have
the number, you cannot
store the message in the
Phonebook. If it was
received as private/
unknown name, the
message will be stored as
<No Name>.
•Even if the 100 memory
locations are full, the
message will be stored in
the Phonebook. However,
the message will be erased
from the Caller ID list.
note
CALLER ID
TRU8885_1st.book 53 ページ ２００４年１月７日 水曜日 午後６時３９分