Filter
Top Products
[34] BASICS
www.uniden.com
Flash and Call Waiting
If you have Call Waiting service and a call waiting
tone sounds while you are on a call, press talk/flash
on the handset or flash/find hs on the base to accept
the waiting call. There is a short pause, and then you
will hear the new caller. To return to the original
caller, press talk/flash or flash/find hs on the base
again.
Placing a Call on Hold
1) During a call, press intercom/hold on the handset or
base. The call will be put on hold.
If you leave a call on hold for more than 10 seconds, the
display screen will read,
Line On Hold
.
2) To talk to the caller, press talk/flash or speaker on a handset (or speaker on the
base). The phone will return back to the call.
*QNFVQVTCPUHGT
*CPFUGV
*CPFUGV
$#%- &'.'6' 1-
•If the battery pack is
completely drained,
the handset will not
beep when paging.
•You must subscribe
through your local
telephone company to
receive Call Waiting or
Caller ID on call
waiting service.
•You can place a call on
hold for 5 minutes.
When 5 minutes has
passed, the call is
disconnected, and the
phone returns to
standby mode.
•While a call is on hold,
CIDCW can not be
received.
note
BASICS
TRU8885_1st.book 34 ページ ２００４年１月７日 水曜日 午後６時３９分