Filter
Top Products
[10] GETTING STARTED
www.uniden.com
B. Install the rechargeable battery pack into the handset, and
charge for at least 15-20 hours before using!
The handset is powered by a rechargeable battery pack. The battery recharges
automatically when the handset is placed in the base unit. To maximize the charge
capacity of your battery pack, DO NOT plug the telephone cord into the base unit
and wall jack until the battery is fully charged.
1) Press down on the handset battery case cover (use the
finger indention for a better grip) and slide the cover
downward to remove.
2) Turn the battery pack so that the connector with the red
and black wires is near the jack inside the battery
compartment. Match the connector's wire colors to the
polarity label in the battery compartment (the connector
notches fit into the grooves of the jack only one way).
Push the battery pack connector into the jack until it
clicks into place.
3) Make sure you have a good connection by gently pulling on
the battery wires. If the connection is secure, the battery
jack will remain in place.
4) Place the battery case cover back on the handset and slide
it upwards until it clicks into place.
5) Place the handset in the base unit for 15-20 hours without
interruption. The base unit's LED light (labeled charge)
illuminates once the handset is placed in the base. The
LED light will illuminate whether the battery pack is
connected or not.
•
Use only the Uniden
(BT-446) rechargeable
battery pack supplied
with your cordless
telephone.
•
Replacement battery
packs are also available
through the Uniden
Parts Department at
(800) 554-3988,
Monday thru Friday from
8:00 a.m. to 5:00 p.m.
or online at
www.uniden.com
note
GETTING STARTED
TRU8885_1st.book 10 ページ ２００４年１月７日 水曜日 午後６時３９分