Filter
Top Products
[78] ADDITIONAL INFORMATION
www.uniden.com
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. De-register all the handsets you have (see “De-register the handset“ on page 32).
2. Register the handsets by following step 2-3 in “Registering the handset“ on page
15.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the
handset. Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from
the holes.
Headset Installation
Your phone may be used with an optional headset. To use
this feature, insert the headset plug into the headset jack.
Your phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden Parts
Department or visiting the web site. See page 81.)
If the battery pack is
completely drained, the
handset will not beep
when paging.
note
ADDITIONAL
INFORMATION
TRU8880_1st.book 78 ページ ２００４年１月７日 水曜日 午後６時３０分