Filter
Top Products
[26] GETTING STARTED
www.uniden.com
Setting the Ring Time
Ring Time allows you to set the number of rings the caller hears before your answering
system plays the outgoing message. You can set the ring time to answer after two, four,
or six rings. If you enable the Toll Saver (TS), the answering system picks up after two
rings if you have new messages and after four rings if there are none.
1) Press the MENU soft key. Select the Answ. Setup
menu, and then the Ring Time submenu.
2) Press /vol/
∧ or /vol/∨ to select a Ring Time
(Toll Saver, 2 Times, 4 Times, or 6 Times).
3) Press the OK soft key. You will hear a confirmation tone.
Setting the Record Time
Record Time sets the duration for recording the incoming messages. You have three
record time options. The options "1 minute" or "4 minutes" set the duration for
recording the incoming messages. "Announce only" answers the call but prevents
the caller from leaving a message.
1) Press the MENU soft key. Select the Answ. Setup
menu, and then the Record Time submenu.
2) Press /vol/
∧ or /vol/∨ to select Record Time (1
Minute, 4 Minutes, or Announce Only).
3) Press the OK soft key. You will hear a confirmation tone.
4KPI6KOG
6QNN5CXGT
6KOGU
$#%- &'.'6' 1-
4GEQTF6KOG
/KPWVG
/KPWVGU
$#%- &'.'6' 1-
GETTING STARTED
TRU8880_1st.book 26 ページ ２００４年１月７日 水曜日 午後６時３０分