Uniden TRU 8880 Cordless Telephone User Manual


 
GETTING STARTED [31]
www.uniden.com
Setting the Dial Mode
Sets the dial mode to tone or pulse. Most phone systems use tone dialing; the
default setting is tone dialing. Set the dialing mode to match the dialing system
used by your local phone service.
If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call. If
the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
If your phone system requires pulse dialing and you need to send DTMF tones in certain
situations during a call, you may switch over to tone dialing (refer to “Tone Dialing
Switch-over” on page 39).
1) Press the MENU soft key. Select the Global Setup menu,
and then the Dial Mode submenu.
2) Press /vol/
or /vol/ to select
Tone
or
Pulse
(the
initial setting is Tone).
3) Press the OK soft key. You will hear a confirmation tone.
&KCN/QFG
6QPG
2WNUG
$#%- &'.'6' 1-
GETTING STARTED
TRU8880_1st.book 31 ページ 2004年1月7日 水曜日 午後6時30分