Filter
Top Products
[10]
• Try to mount your phone within 1.5m of a working phone jack to avoid
excessive cord lengths.
• Make sure the wall material is capable of supporting the weight of the base
and handset.
• Use #10 screws (minimum length of 35mm) with anchoring devices suitable
for the wall material where the base unit will be placed.
1) Insert two mounting screws into the wall, (with their appropriate
anchoring device), 100mm apart. Allow about 3mm
between the wall and screw heads for mounting the phone.
2) Refer to steps 1 through 9 on page 9 to mount the telephone.
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
Pull both sides of the beltclip to release the tabs from the holes.
Your phone may be used with an optional headset.
To use this feature, insert the headset plug into the headset jack.
Your phone is ready for hands-free conversations.
(Headset may be purchased by visiting our website at;
www.uniden.com.au or www.uniden.co.nz )
Installing the Beltclip
To attach the beltclip
To remove the beltclip
Headset Installation
3mm
100mm