Filter
Top Products
7
Step 2
(continued)
Connect the base unit
If you want to install the base unit on the wall, see page 47.
1 Connect the telephone line cord to
the
TEL LINE jack and to a
telephone outlet.
Note Until the handset battery is
fully charged, you can only
answer incoming calls at the
base unit.
2 Connect the AC adapter to the
DC IN 9V jack and to a standard
120VAC wall outlet.
3 Set the base unit on a desk or table-
top and place the handset on the
base unit.
Then raise the antenna to a
vertical position.
3
Note
Place the power cord where it will not create a trip hazard, or where it could become
chafed and create a fire or electrical hazard.
EXAI 6980 2nd HEN 10/31/00 10:06 AM Page 7