Filter
Top Products
1 Call your telephone number.
2 While the greeting message plays, press # and your PIN code. If the answering
machine is off, let it ring 10 times until the greeting message plays.
Then, press
# and your PIN code.
3 The answering system announces the time and day stamp and the number of mes-
sages stored in memory. Then the Message playback automatically begins.
4 You may continue to listen to your messages or you may select a command from
the following chart:
5 After all of your messages have played, or the playback time exceeds 4 minutes,
you will hear intermittent tones indicating that the system is in the command wait-
ing mode. You may enter another command at this time from the chart above.
6 When you are finished, hang up to exit the system. The answering system
automatically returns to standby.
Command Function
# then 1 Repeat
# then 2 Playing your messages
# then 3 Skipping a message
# then 4 Deleting a message
# then 5 Stop message playback
# then 6 Answering system on
# then 7 Voice memo record/stop
(up to 4 minute recording time)
# then 8 Greeting message record/stop
# then 9 Answering system off
# then Room monitor
43
Using the answering machine
(continued)
Remote access away from home
You can operate your answering system from a remote location using any touch-tone
telephone. Use this function to check for recorded messages, to play or delete
messages, even to record a new outgoing message, and to monitor sounds in the
room.
*
Notes
• During the remote operation, rC displays on the base.
• You must enter a command within 15 seconds of entering the command waiting
mode or the answering system automatically hangs up and returns to standby.
• The system will only play back messages for four minutes and then it returns to the
command waiting mode. To continue playing your message, press
#
then
2
again
within 15 seconds
EXAI 6980 2nd HEN 10/31/00 10:06 AM Page 43