Filter
Top Products
[21] USING THE SPEED DIAL MEMORY
www.uniden.com
4) Enter a name according to the instructions below, then press the select/remote key. If no
name is required, go to step 5.
• The name can be up to 13 characters.
•Use the #/ and
*
/tone/ keys to move the cursor to the desired location.
•Use the delete/chan key to delete characters as needed.
• Press and hold the delete/chan key to delete all the characters.
Refer to the letters on the number keys to select the desired characters.
With each press of a numeric key, the displayed character appears in the following order:
upper case letters first, lower case letters next and finally the number corresponding to
the key.
If you make a mistake while entering a name
Use the
*
/tone/ or #/ key to move the cursor to the incorrect character.
Press the delete/chan key to erase the wrong character. Then enter the correct character.
To delete all characters, press and hold the delete/chan key.
For example, to enter Movies.
1) Press 6. Then press the #/ key to
move the cursor to the right.
2) Press 6 six times.
3) Press 8 six times.
4) Press 4 six times.
5) Press 3 five times.
6) Press 7 eight times.
Number of times key is pressed
keys 1 2 3 4 5 6 7 8 9
2abc
3def
4ghi
5jkl
6mno
7pqrs
8tuv
9wxyz
0
1
oper
If the next character
uses the same number
key, you must press the
#/ key to move the
cursor over. Otherwise
the next time you press
the number key, it
changes the character
that was previously set.
note
USING THE SPEED
DIAL MEMORY
EXAI7248.book Page 21 Thursday, December 14, 2006 11:57 AM