Filter
Top Products
GETTING STARTED [ 11]www.uniden.com
GETTING STARTED
5) Once the handset battery pack is fully charged,
connect the telephone line cord to the TEL LINE
jack and a telephone outlet once the handset is
fully charged.
If your telephone outlet isn't
modular, contact your telephone
company for assistance.
Modular
D. Choose the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However some phone systems still use pulse dialing such as in rural areas.
The default setting is tone dialing. Depending on your dialing system, set the mode
as follows:
1) Press and hold the flash key until you hear a confirmation tone.
2) To set the dial mode for pulse dialing, press the # key.
Or to set the dial mode for tone dialing, press the
*
/tone key.
You hear a confirmation tone to indicate the setting is complete.
• Make sure your battery
pack is fully charged
before choosing the
dial mode.
• If you are not sure of
your dialing system,
set for tone dialing.
Make a trial call. If the
call connects, leave
the setting as is, oth-
erwise set for pulse
dialing.
• If your phone system
requires pulse dialing
and you need to send
DTMF tones for certain
situations during a
call, you may “switch-
over” to tone dialing.
(Refer to “Tone Dialing
Switch-over” on page
16.)
EXA3245.Qx 1/27/3 10:00 AM Page 11