Filter
Top Products
GETTING STARTED [ 9]www.uniden.com
GETTING STARTED
Battery use time (per charge)
From fully charged (15-20 hours charge time)
• Up to seven hours continuous use during the talk mode.
• Up to fourteen days when the handset is in the standby mode.
Low battery alert
When the battery pack is very low and needs to be charged, the phone is programmed
to eliminate functions in order to save power. If the phone is not in use, the
talk/batt low LED flashes when the battery pack is low.
If the phone is in use, the talk/batt low LED flashes and the handset beeps.
Complete your conversation as quickly as possible and return the handset to the base
unit for charging.
Cleaning the charging contacts
To maintain a good charge, it is important to clean the
charging contacts on both the handset and base unit
once a month. Use a dry cloth or pencil eraser to clean.
If the contacts became very dirty, using water only,
dampen a cloth to clean the charging contacts.
Then make sure to go back over the charging contacts
with a dry cloth before returning the handset to the
base to charge.
The last number dialed in the redial memory and the numbers
stored in the memory locations are retained for up to 1 minutes
while you replace the battery pack.
• Even when the battery
pack is not being
used, it will gradually
discharge over a long
period of time. For
optimum performance,
be sure to return the
handset to the base
unit after a telephone
call.
• Talk Mode - The
handset is off the base
and talk has been
pressed enabling a dial
tone.
• Standby Mode - The
handset is not in use,
off the base, and talk
has not been pressed.
A dial tone is not
present.
EXA3245.Qx 1/27/3 10:00 AM Page 9