Filter
Top Products
5 Press or to display either
Tone
or
Pulse
and press to confirm.
6 Press to exit and return to standby.
Tone Dialing Switch-Over
If you have set your phone to use Pulse dialing,
you can switch temporarily to Tone dialing for the
duration of a call:
1 Press .
2 Enter the number you want. Press and
hold ,
D
will be displayed.
Any digits entered after the
D
will be dialed
using tone dialing.
Registering a new handset
When you register a new handset to your base,
you will be asked to enter the base PIN code.
The pre-set PIN code is 0000. If you wish you can
change this code, see page 29.
Before registering, make sure the new handset is
fully charged and that you have the base and
handset in front of you. Also, make sure all
handsets and the base are in standby.
On the handset you want to register:
1 Press to access the main menu.
2 Press or until
Add.settings
is
displayed and press .
3 Press or to display
Register
and
press
.
4 Press or to select your base
number and press .
On your base:
5 Press and hold for approx. 3 seconds.
You are now in ‘registration mode’.
[27]
UC01501BB_0 8/9/06 2:49 PM Page 27