Filter
Top Products
QUICK REFERENCE GUIDE [ 5]
Q
UICK
R
EFERENCE
G
UIDE
Step 3 Using the Phone
TO SELECT CALLER ID OPTIONS
Press the MENU soft key in the
standby mode.
Press volume/ ▲ or ▼ to select
“Global Setup”, then the
OK soft key.
Press volume/ ▲ or ▼ to select
“CIDCW”, then the OK soft key.
Press volume/ ▲ or ▼ to select
“CW On/CWDX On”,
“CW On/CWDX Off”, or
“CW Off/CWDX Off”,
then the OK soft key.
TO CHOOSE THE LANGUAGE
Press the MENU soft key in the
standby mode.
Press volume/ ▲ or ▼ to select
“Handset Setup”, then the
OK soft key.
Press volume/ ▲ or ▼ to select
“Language”, then the OK
soft key.
Press volume/ ▲ or ▼ to choose
a Language, then the OK soft key.
SUN 12:00A
Handset #1
New: 5
MENU CID
RDL
PB
INSTALL THE AA BATTERIES
Remove the cover.
Install the batteries,
observing the
correct polarity.
Replace the cover.
PLUG INTO AC POWER
Plug the AC adapter cord into
the base unit and then to a
120V AC outlet.
Place the handset in the base.
Note:
You must charge the batteries
continuously
for 17-20 hours
before using the phone.
Step 1 Charging the Batteries Step 2 Connecting
Step 4 Setting up
Answering System
CONNECT TO A PHONE LINE
When the handset batteries are fully
charged, plug the telephone cord into
the base unit and then into a telephone
wall jack.
Your phone is set for tone dialing. If your
local network requires pulse dialing, please
see “Setting the Dial Mode” on page 30.
TO TURN THE ANSWERING
SYSTEM ON/OFF
Each time ans on is pressed, the
answering mode is switched between
On and Off.
TO SET GREETING MESSAGE
Press and hold greeting.
Start recording your message.
Position yourself as near to
the base as possible.
When finished, press greeting
or .
DCT5280_UP302BH UP01302BA_1 5/23/03 1:54 PM Page 5