Filter
Top Products
ADDITIONAL INFORMATION [ 41]
Register the Security Code
1) Unplug the AC adapter.
2) Press and hold
find handset on the base while you plug in the AC Adapter until
the status LED on the base flashes.
3) Press
talk/flash. “Handset Registering” appears.
When the operation is finished “
Registration Complete” appears and the
status LED is turned Off. You will hear a confirmation tone and the phone returns
to the standby mode.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down
until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
Your phone may be used with an optional headset, the Uniden HS910. To
use this feature, insert the headset plug into the headset jack. Your phone
is ready for hands-free conversations. (Headset may be purchased by calling
the Uniden Parts Department or visiting the web site. See Page 9.)
Headset Installation
ADDITIONAL
INFORMATION
• You must complete the registration operation within 30 seconds, or the phone returns to
standby mode.
• During the registration operation, you cannot receive an incoming call, page, or make a call.
TRU446_OM 4/9/02 10:44 AM Page 41