Filter
Top Products
[ 23 ]
BASICS
Find Handset
Flash and Call Waiting
BASICS
Selecting a Different Channel
If you encounter interference while using your phone, you can manually change the phone’s
channel for clear operation. This function works only when the phone is in use.
Press select/ch. “Scanning” appears on the display, indicating the phone is changing to
another channel. For more information on interference, refer to “Radio Interference” on
page 46.
• You must subscribe
through your local
telephone company
to receive Call
Waiting Service.
• If the handset
battery is
completely drained,
the handset will not
beep when paging.
To locate the handset, press find handset on the base. The handset
beeps for 60 seconds, and “Paging” appears on the display.
Paging is canceled when pressing any key on the handset or
find handset on the base. Additionally, if you receive an
incoming call, page is canceled.
If you have Call Waiting service and a call waiting tone sounds while you
are on a call, press talk/flash to accept the waiting call. There is a short
pause, then you will hear the new caller. To return to the original caller,
press talk/flash again.
Voice Mail LED
The voice mail LED on the handset is designed to work with your voice
mail service provided by your local telephone company. The LED flashes
when you have new incoming messages in the voice mail service.
You may need to occasionally reset the indicator if it remains On after
you’ve retrieved your messages. To reset the indicator, when the phone is
in the standby mode press and hold find handset on the base until the
paging sound stops (about 5 seconds).
TRU446_OM 4/9/02 10:43 AM Page 23