Ultratec Miniprint 425 Telephone User Manual


 
Printer
The printer does not work.
Be sure the printer is on.You can also try resetting the printer
by turning the Miniprint 425 off and on.
The printer works, but it prints too lightly or not at all.
Make sure you have high-grade thermal printer paper and it is
correctly installed. See Replacing the printer paper on page
30.
The printer prints only the bottom half of characters.
The print head should be replaced. Contact your dealer or
Ultratec.
On battery power, the printer prints too slowly or lightly.
The batteries are low. Plug in the AC adapter for 24 hours to
recharge the batteries.
Power
The batteries run down too soon.
You may not be regularly using your Miniprint 425 on battery
power, or the batteries are old. See About the batteries on
page 31.
The Miniprint 425 does not turn on when you press the
On/Off switch, or the power light blinks even when the
AC adapter is plugged in.
Be sure the electrical outlet is working. Be sure you are using
the correct AC adapter—it should be a 9VDC, 650 ma adapter.
If you still have a problem, contact your dealer or Ultratec.
The Miniprint 425 works fine in the evening, but does not
work during the day.
You may have plugged the AC adapter into a switch-
controlled outlet.Try a different outlet that you are sure is not
controlled by a switch.
34 • CARE & REPAIR