Filter
Top Products
Charging the batteries
The AC adapter supplies electricity to the Miniprint 425 and
charges the built-in batteries. Leaving the AC adapter plugged
in will not harm the Miniprint 425 or the batteries.
The first time you set up your Miniprint 425, leave the AC
adapter plugged in for 24 hours to charge the batteries.You
can use the Miniprint 425 at the same time. Fully-charged
batteries will provide 45 to 60 minutes of normal use. For
more information on using battery power, see About the
batteries on page 31.
What kind of telephone line?
When the telephone line is directly connected to the
Miniprint 425, you need a standard (analog) home telephone
line with either pulse or tone dialing. If you plan to use the
Miniprint 425 in an office, the line may need modification
because many offices have digital telephone systems. Contact
your telephone installer to be sure your line supports a
standard single-line home telephone.This is the same kind of
line you need for many fax machines or computer modems.
Caution! Do not plug the Miniprint 425 into any line other
than a standard telephone line. If you do, you may damage
your telephone system or the Miniprint 425.You will also
void your warranty.
Setting pulse or tone dialing
Your Miniprint 425 comes set for tone dialing, which is used
by most telephone lines. If your telephone line uses pulse
dialing, change the Miniprint 425 setting to pulse dialing. See
Setting pulse/tone dialing on page 26 to change the setting.
Connecting a signaler or telephone
The Miniprint 425 has an extra jack for a telephone or a
signaler.You can use either jack for the telephone line and
telephone or signaler.
SETUP • 9