Filter
Top Products
Topcom Butler 5500
ENGLISH
Topcom Butler 5500 113
•Press MENU then scroll to Registration and press OK.
• Scroll to Select Base then press OK. The current base being used is highlighted.
• Select the base you want or select Automatic to connect to the base with the strongest signal. Press OK.
Note: When you do Automatic base selection, the handset will only search in standby for the strongest base when it’s
out of range on the current base (not during communication)!
10.4 USING THE INTERCOM FEATURE
10.4.1 Calling an internal handset
•Press INT. The screen displays "Internal Call".
• Enter the internal handset number.
10.4.2 Transfer a external call to another handset
During a external call:
•Press INT.
• Enter the number of the handset you want to call. Your external correspondent is placed on hold. When the internal
correspondent answers, press to transfer the call. If the internal correspondent doesn't answer, press INT to
retrieve the external correspondent or to go from one to the other.
10.4.3 Conference call
You can talk between 2 handset and a external line at the same time. During an external call:
•Press INT.
• Enter the number of the handset you want to call. Your external correspondent is placed on hold.
• When the internal correspondent answers, press ‘#’ for 2 seconds. If the internal correspondent doesn't answer,
press INT to retrieve the external correspondent.
10.4.4 TAKING AN EXTERNAL CALL DURING AN INTERNAL COMMUNICATION
When you are on intercom with another handset, you can still pick up outside calls.
To take an incoming call:
• Press . The internal communication is interrupted.
• Then press .You are in communication with the outside caller.
11 GAMES
The Butler 5500 has 5 games:
•Press MENU then scroll to Games and press OK.
• Select a game and press OK. Press START to display the game menu which includes instructions.
•Press BACK to exit.
12 TROUBLESHOOTING
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the batteries
Recharge the batteries
Handset turned OFF Turn ON the handset
No tone Telephone cord badly connected Check the telephone cord connection
The line is occupied by another handset Wait until the other handset hangs up
The icon flashes
Handset out of range Bring the handset closer to the base
The base has no power supply Check the mains connection to the base
The handset is not registered on the
base
Register the handset on the base
Base or handset do not ring The ringing volume is zero or low Adjust the ringing volume
Tone is good, but there is no
communication
The dialling mode is wrong Adjust the dialling mode (pulse/tone)
Not possible to transfer a call on PABX The FLASH time is too short Set the unit to Long Flash time
Telephone does not react to pressing the
keys
Manipulation error Remove the batteries and put them back
in place