Filter
Top Products
Operating Your System
24
To set your system to Tone
or Pulse Dialing:
At Station #1
1:
1
Press PROGRAM.
- The display will read “Program...”
2 Press the soft key under NEXT
repeatedly, until “Advanced Setting”
appears in the display, and then
press ENTER.
3 Press the soft key under NEXT until
“Tone/Pulse” appears in the display,
and then press ENTER.
The display will show the current
tone/pulse setting
4 Press the soft key under CHANGE
repeatedly, until the desired
tone/pulse setting is displayed.
The choices are:
Dial: TONE (factory setting)
Dial: PULSE
5 Press PROGRAM to exit.
The Tone or Pulse dialing selection is made at
Station #11, and this setting governs the entire
system.
If any of your telephone lines have Pulse serv-
ice, you must select Pulse Dialing.
If all your lines have Tone Service, leave the set-
ting at Tone Dialing.
If your system is set to Pulse Dialing, you may
press the
*
button to change the dialing mode
temporarily to tone during a call.
This feature is useful if you have to send tone
signals for access to telephone banking, long
distance or other special services. Dialing mode
will revert to pulse when you hang up.
Making a Tone/Pulse Selection
Press the
*
button to send
tone signals if your system is
set to Pulse Dialing
ET4000 UG for PDF v8 062502.qxd 6/25/02 12:52 PM Page 34