Filter
Top Products
Step 4: Install Wall Mounted Phones (Continued)
7
5 Assign a Station Number
Refer to page 8 for detailed instructions on
assigning a station number.
6 Install a 9-Volt Battery (Optional)
It is not necessary for you to install a battery in
your Epic telephone for it to function normally.
In fact, a battery is not even needed to pre-
serve your memory dial numbers in the event
of a power failure. This is because all memory
dial numbers are stored in a static memory
which retains its contents even with no electri-
cal power. The only purpose of having a bat-
tery installed is so that the telephone itself can
function for up to two hours in the event of a
power failure. You may wish to install a battery
in at least one Epic phone for emergency oper-
ation, or have another standard phone avail-
able. If you wish to install a battery, refer to
page 68 for detailed instructions.
7 Attach Telephone to Wall
Hold the telephone close to the wall and con-
nect the short telephone line cord to the jack.
Then mount the telephone to the wall plate,
sliding it down firmly so that it locks securely in
place.
8 Verify Proper Installation
IMPORTANT: Please remember to perform the
procedure on page 9, after you assign each
station number, to verify that each telephone is
properly installed.
Installing Your System
ET4000 UG for PDF v8 062502.qxd 6/25/02 12:51 PM Page 17