Filter
Top Products
SX6P
Setup
RUIM Card Installation (RUIM Model Only)
Consult your service provider to determine if your unit requires the use of a RUIM (Removable User
Identity Module). If it is a RUIM model, your SX6P will only be able to place emergency calls until you
install a RUIM card. It will not receive calls or allow non-emergency outgoing calls without the RUIM
card installed. For an explanation of how to configure your RUIM once your SX6P is set up, see
RUIM Usageon page 5.
1. Remove the power cord if it has already been connected. The power cord must be removed
whenever a RUIM Card is removed or installed.
2. Remove the RUIM compartment cover. - see Figure 1.
3. Open the RUIM compartment holder.
4. Line up the RUIM card with the arrow on the RUIM card holder - see Figure 2.
5. Gently insert the RUIM card in the slot of the RUIM card holder.
6. Close the RUIM card holder.
7. Reattach the RUIM compartment cover, closing it with the separate cover screw provided.
RUIM Compartment Cover
RUIM Card
Holder
RUIM Card
Figure 1 - RUIM compartment cover.
Cover Screw
Figure 2 - RUIM card installation.
Note:
Do not force the RUIM card holder shut. Make sure the RUIM card is aligned properly with the
directional arrow on the holder.
Phonecell
®
SX6P CDMA 1 User Manual