Filter
Top Products
3. Install the screws (not supplied) into the wall, leaving a gap of approximately 3 mm (1/8 inches)
between the screw head and the wall.
4. Align the mounting holes with the screws and mount the SX6P onto the screws - see Figures 10
and 11
.
Connecting the SX6P to AC Power
1.
Connect the DIN connector of the AC power cord into the AC power input on the rear panel of
the SX6P - see Figure 12.
2. Plug the AC power cord into the wall socket.
3. Check the cellular signal strength and move the unit until the best signal possible is
achieved - see the Service Indication section of this manual on page 7.
AC Power Cord
Wall Socket
AC Power
Input
DIN
Connector
Figure 12 –
SX6PAC power connection.
Figure 11 – Mount the SX6P onto the screws.
83 mm (3-1/4 inches)
Figure 10 – SX6P mounting hooks.
Mounting
Holes
Phonecell
®
SX6P CDMA 4 User Manual