Filter
Top Products
ANALOG FAX OPTION
The Analog Fax option allows connection of a fax machine and additional telephones to the
SX5D. The SX5D can be set up to use one or both of its RJ-11 jacks. In Single Jack mode, only
the jack designated with a telephone icon is operational. A fax machine or an additional tele-
phone can be connected to that jack, but to receive faxes a fax machine must be connected. In
Dual Jack mode, the unmarked jack is used for fax, and the jack marked with the telephone icon
is used for any additional phones.
Analog Fax Setup
1) Press the MENU key.
2) Select Settings, then select Fax Settings.
3) Select RJ-11.
4) Select the desired mode (Single Jack or Dual Jack). The default is Dual Jack.
Connect SX5D for Dual Jack Mode
1) Connect a fax machine to the unmarked phone jack on the SX5D - see Figure 22.
2) Connect a regular phone to the phone jack that is marked with a telephone icon.
Connect SX5D for Single Jack Mode
1) Connect a fax machine to the phone jack on the SX5D that is marked with a telephone icon -
see Figure 23.
NOTE: In single jack mode, the SX5D default is for voice calls, so a fax by-pass must be entered
to send faxes. After a fax is sent, the SX5D will automatically reset itself for voice calls.
Set SX5D for Digital Fax
1) Press the MENU key.
2) Select Settings, then select Fax Settings.
3) Select Serial Port.
NOTE: The SX5D must be connected to a computer, or other device that is set up for digital
data, via the serial connector in order to send or receive digital faxes.
Phonecell
®
SX5D GSM 34 Technical Manual
This RJ-11 is not usable
Figure 22 - Connect the SX5D for dual jack mode. Figure 23 - Connect the SX5D for single jack mode.
OR
To unmarked jack