Filter
Top Products
Operation
Channel Select (WM2000 Only)
Tap the Ch Select key to select channel 1 or 2. The key is green when channel 1 is se-
lected and red when channel two is selected.
Receiving Calls
1. When there is an incoming call signal the Call key will flash red. There will also
be a beep tone in the headphones if the beep feature is activated (page 6).
☞
WM2000 only: incoming call indication is provided only for the currently se-
lected channel.
2. Turn on the Talk and Listen keys and begin your conversation. Turn the keys off
when finished.
☞
You can turn the talk and listen keys on in either momentary or latched mode.
For momentary operation, press and hold the key. For latched operation, tap the
key to turn it on. Then tap it again to turn it off when finished.
Calling an Intercom Channel
1. WM2000 only: select the desired intercom channel.
2. Press and hold the Call key. An inaudible call signal will be sent, and the Listen
key will automatically turn on.
3. When you hear a response, release the Call key and activate the talk key.
4. Turn off your Talk and Listen keys to end the conversation.
17