Tandberg Data 150 MXP Telephone User Manual


 
1 TANDBERG 150 MXP
5
1.3 Connecting Cables
Connect the cables as shown on the figure:
1. Plug for handset (optional)
Handset is not included with the TANDBERG 150 MXP, but is an accessory device. Contact
your TANDBERG representative for more information.
2. Plug for headset (optional)
The TANDBERG 150 MXP has a 2.5mm 3-pole mini-jack connector at its right side marked
with a headset symbol. This allows the user to connect a standard telecommunications headset
to the system. Headsets with the microphone positioned in front of the users mouth, connected
to the earphone through a rod, tend to give more echo than earbud headsets with the
microphone attached to the cord. TANDBERG recommends the Plantronics MX100 headset
(www.plantronics.com, products mobile). Note that the maximum outer diameter of the plug
must be 7,0 mm or smaller. A plug with a bigger outer diameter will not fit the unit. Alternatively
an extension cord may be used.
3. Power cable