Filter
Top Products
SETTING
UP
AC
POWER
ADAPTER
Plug the
AC
power adaptor into an
electrical outlet and the
DC
connector
to the back of the Base Unit'.
I
CAUTION:
USE CLASS 2,
9V
A
DC
POWER
SUPPLY ONLY.
SETTING RINGER
The Handset ringer is programmed
ON
as the factory default setting. To
change ringer settings, see
RINGER
TONE
1
VOLUME.
The Base Unit ringer is controlled
independently, by a switch located on
the front, right hand side
(8ntenna
side) of the Base.
The Base ringer have
3
settings,
High, Low and Off.
TONUPULSE SELECTION
Your
Sprint
1733 is preset for
Tone
dialing. If you have rotary (pulse)
service, program the Handset
accordingly. See
SET TONWPULSE
for details.
CHARGETHE HANDSET BAllERY
PACK BEFORE USE.
The battery pack recharges
automatically whenever the Handset
is in the Base Unit. The battery pack
must be charged for
16
hours before
using your phone for the first time.
CONNECT THE TELEPHONE
LINE CORD
Plug one end of the telephone line
cord into the jack on the back of the
Base Unit, plug the other end of this
cord into the wall jack.
CHECK FOR A
DIAL
TONE
After the battery is charged. rotate
the Base Unit antenna to upright posi-
tion. Now press
PHONE
on the Hand-
set.
PHONE. ON
will appear on the
LCD, and you will hear a dial tone. If
not, see
IN
CASE OF DIFFICULTY.
Fill in the telephone number card on
1
the Base Unit.
CAUTION:
1.
Never install telephone wiring dur-
ing a lightning storm.
2. Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet loca-
tions.
3.
Never touch uninsulated tel-
ephone wires or terminals unless
the telephone line has been dis-
connected at the network inter-
face.
4.Use caution when installing or
modifying telephone lines.