Filter
Top Products
Getting Started
21
US
Getting Started
#1 #2 #3 #4 #5
4 Turn Jog Dial up to make “LOCAL” flash, and
then press Jog Button.
5 Select the number (“#1” to “#5”) to enter the
local area code by turning Jog Dial, and then
press Jog Button.
6 Enter three digits of the local area code by
pressing the dialing keys.
7 Press Jog Button.
The number next to the selected number will
flash and you will hear a long confirmation
beep.
Repeat steps 5 to 7 to enter a local area code
into another number, if necessary.
To end the setting, press (ERASE/CLEAR).
Note
Do not allow more than 20 seconds to elapse between each step of the procedure.
Tip
You can press (PROGRAM) instead of Jog Button in the procedure above.
To change the local area code
1 Display the local area code you want to change by doing steps from 1 to 5
on pages 20 to 21.
The current local area code appears on the display.
2 Enter a new local area code by pressing the dialing keys.
3 Press Jog Button.
You will hear a long confirmation beep.
Tip
You can also correct a digit in step 2. Turn Jog Dial until the digit to be corrected flashes and
enter a digit by pressing the dialing keys.
To erase the local area code
1 Display the local area code you want to erase by doing steps from 1 to 5
on pages 20 to 21.
The current local area code appears on the display.
2 Press (ERASE/CLEAR).
3 Turn Jog Dial to choose “YES”, and then press Jog Button.
You will hear a long confirmation beep and the local area code is erased.
#1 #2 #3 #4 #5