Filter
Top Products
Enter master 3 beeps for valid
password to password. 1 long
programming mode beep for invalid
password.
[1] - Master password
[2] - Secondary password
[3] - Duress password
Select any 4-digit pass-
word, each digit can be
from 0 to 9
Enter the new password 3 beeps if new pass-
again for confirmation word is accepted. You
will hear [Password
Accepted]
Programming Passwords
Master Password can be used for programming, arming, disarming the
system, and telephone access. The default Master Password is [1234].
Secondary Password can be used for arming, disarming the system, and
telephone access. Secondary Password cannot be used for programming.
The default Secondary Password is [0000].
Duress Password is used when you are forcibly compelled to disarm the
control panel. Entering the duress password will stop the siren from sounding
but the control panel will silently call the emergency phone numbers for help.
The default Duress Password is [3838]. You should definitely change this
password and let all the users know this password.
Changing Passwords
It is strongly recommended to change all 3 passwords when you first set
up the system.
In order to change the password, follow the procedures below.
INSTALLATION
[PROG]
[MPIN]
[2]
[1] or
[2] or
[3]
[new
4-digit
password]
[new
4-digit
password]
Enter
Programming
mode
Select
password
programming
Select which
password to
change
Enter new
password
Enter new
password to
confirm
1
2
3
4
5
–
9
–
Step Keys Function Description Note
After mounting the door sensor, it - Please ensure the magnet is aligned with
doesn’t work anymore. the red marking on the transmitter.
- If you are mounting the sensor on to a
metal door or window, a spacer may be
required to avoid magnetic interference
caused by the metal door / window.
- Make sure the sensor is within the operation
range of the control panel by bringing it
closer to the control panel.
My motion sensor is not very The motion sensor is designed to detect the
responsive, sometimes when I walk “First Motion”. First Motion means no motion
by it, the control panel doesn’t respond, is detected within the past 20 seconds,
but sometimes it does. and if a motion is then detected, that is the
“First Motion”. So if you continue to walk
in front of the motion sensor, it will only
pick up the first motion. Unless you wait
for 20 seconds, then walk again, the control
panel will respond. Otherwise, the control
will only respond to the first motion.
TROUBLE SHOOTING
When a sensor is triggered, the - Make sure the battery in the sensor is
control panel doesn’t respond at all, installed properly, pay attention to the
what is the problem? polarity.
- Make sure the sensor is learned to the
control panel. Follow instructions on
page 37 on how to learn a sensor.
- You may try to bring the sensor closer to
the control panel, ensure it is not out of
the operation range.
My motion sensor sometimes gets Ensure the motion sensor is not facing
triggered by itself, how can I prevent direct sunlight, nor any A/C or furnace
that? vents. You may also reduce the sensitivity
to low. If your motion sensor is located
outdoors, you may want to relocate it.
Sensors
–
48
–