Filter
Top Products
35
SK 100 G2 / SK 300 G2 / SK 500 G2 bodypack transmitters
Using the bodypack transmitter
Switching the transmitter on/off
The transmitter can only be switched off when the standard display
is shown on the display panel. When in the operating menu, briefly
pressing the ON/OFF button will cancel your entry (ESC function)
and return you to the standard display with the last stored settings.
Note:
Remove the batteries or the rechargeable battery when the
transmitter will not be used for extended periods of time.
̈ Press the two unlocking buttons µ and open the battery com-
partment cover ¾.
̈ Press the ON/OFF button ¸ to switch the transmitter on. The red
LED » lights up.
̈ To switch the transmitter off, press the ON/OFF button ¸ until
“OFF” appears on the display. The red LED » goes off.
̈ Close the battery compartment. The battery compartment cover
¾ locks into place with an audible click.
Muting the transmitter
The transmitter has a MUTE switch that noiselessly mutes the
transmitter’s audio signal without switching the transmitter off.
̈ Set the MUTE switch ¹ to the position ’MUTE’. The “MUTE” dis-
play appears on the display panel.
̈ Set the MUTE switch Ƹ back to the original position to retrans-
mit the audio signal.
Operation and battery status indication
The red LED (LOW BAT/ON) ᕣ provides information on the current
operating state of the transmitter:
Red LED lit up: The transmitter is switched on and the capacity of
the batteries/BA 2015 rechargeable battery is sufficient.
Red LED flashing:The batteries are/the BA 2015 rechargeable bat-
tery is going flat (LOW BAT)!
µ
¾
¸
»
Ƹ
µ
¾
¸
»