Filter
Top Products
21
Using the receiver
To copy the settings:
̈ Place the receiver with “master” function above the infra-red
interface of the other receivers (slaves), one after the other. The
distance between the infra-red interfaces ¹ of both receivers
(master and slave) must not exceed 10 cm.
The settings are copied and the text “COPY” briefly appears on
the display of the receiver (slave). If data transfer was success-
ful, the receiver (slave) switches off automatically.
Note:
Strong extraneous light may interfere with the data transfer via
the infra-red interface. Therefore, position the receivers so that
any possible interference caused by extraneous light is avoided.
The arrow in the diagram on the left indicates the direction from
which the IR radiation must impinge upon the receiver.
Master
Slave