Filter
Top Products
8
GETTING STARTED
To register the second handset
(For CLT-U12, CLT-U22 & CLT-U32)
The second handset (charge in the extra charging cradle) must also be registered
to the main base before use.
1. Be sure both handsets are fully charged.
2. Remove the handset from the charging cradle, and place it in the main base.
3. Wait for at least 5 seconds before removing the handset from the main base.
4. After both handsets are registered, it doesn’t matter which handset is placed
in the main base or the charger.
5. The charge/in use LED lights on the main base.
Note:
• After a power failure occurs or battery replacement, both handsets will need
to be re-registered. To re-register, follow the same registration process as
above.
• If the handset’s battery becomes very low, the handset must be recharged
for 12 hours and re-registered to the main base unit.
5. Slip the mounting holes over the wall plate posts and slide the unit down
firmly into place. (Wall plate not included.)
6. Place the handset in the base.
Note: If desired, gather the extra AC adaptor cord and telephone cord
together, fasten with a wire tie, and store inside the wall mounting bracket.
Register handsets to the main base before use
Your cordless phone uses a digital security system to provide protection
against false ringing, unauthorized access and charges to your phone
line. When you place the handset in the main base, the handset will
automatically register to the base.