Sanyo CLT-U12 Cordless Telephone User Manual


 
27
TROUBLESHOOTING
CHARGE/IN USE LED ON BASE KEEPS FLASHING
Provided your phone company offers voice mail indicator service and you
subscribe to it, the CHARGE/IN USE LED flashes when the phone is in use
to indicate there is a message waiting. It stops flashing after the message
has been reviewed.
Causes of poor reception
Aluminum siding.
Foil backing on insulation.
Heating ducts and other metal construction can shield radio signals.
You are too close to appliances such as microwaves, stoves, computers,etc.
Atmospheric conditions, such as strong storms.
Base is installed in the basement or lower floor of the house.
Base is plugged into an AC outlet with other electronic devices.
Baby monitor is using the same frequency.
Handset battery is low.
You are out of range of the base.
To keep your telephone working and looking good, follow these guidelines:
Avoid putting the phone near heating appliances and devices that
generate electrical noise (for example, motors or fluorescent lamps).
Do not expose to direct sunlight or moisture.
Avoid dropping the phone, and other rough treatment to the phone.
Clean the phone with a soft cloth.
Never use a strong cleaning agent or abrasive powder because this will
damage the finish.
Periodically clean the charge contacts on the handset and base with a
clean pencil eraser.
Retain the original packaging in case you need to ship the phone at a later
date.
MAINTENANCE