Sanyo CLT-U12 Cordless Telephone User Manual


 
12
Resetting to default
You can reset the phone programming to the initial factory default settings. The
default settings are:
Language English
Area Code - - -
Ringer Tone 1
Tone/Pulse Setting Tone
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG repeatedly until “DEFAULT 1 NO” shows on screen.
3. Press CID
or , or the 1 or 2 keys to select your choice.
4. Press FLASH/PROG again to confirm. You will hear a confirmation tone.
INITIAL PROGRAMMING
Receiving a call
When receiving an incoming call, the LED on the handset flashes, and the handset
will show caller information. *
* Note: A subscription is required from your local phone company to receive
Caller ID information on your phone. See Caller ID Features, page 16.
1. Press TALK to answer the call.
Note: If handset is in the base cradle, remove it from base before pressing
the TALK key. Either handset 1 or handset 2 can answer the call at once.
(for CLT-U12, CLT-U22, and CLT-U32)
2. Press TALK to end your call.
Note: If you replace the handset to the base cradle or charger cradle (for
CLT-U12, CLT-U22, and CLT-U32), the handset automatically hangs up.
BASICS