Filter
Top Products
8
Each Line on a Separate Modular Jack
1. Make sure wall mount bracket is securely fastened.
2. Set the T/P switch to T for touch-tone service, or P for pulse (rotary)
service. If you don’t know which type of service you have, check with
the phone company.
3. Raise the base antenna.
4. Set the RING switch to ON so the handset rings for incoming calls.
5. Plug one of the telephone line cords into the L2 jack and into a single
line modular jack. Connect the remaining phone cord to the L1 and L2
phone jack located on the back of the phone and into a single line
modular jack.
6. Plug the power supply cord into the base and into an AC outlet.
7. Place handset in the base to charge for 12 hours. The CHARGE/PAGE
light comes on indicating that the battery is charging. If you don’t
charge the handset battery properly (for 12 hours) when you first set up
the phone, the battery’s long-term performance will be compromised.
T/P switch
2
5
CAUTION: Use only the Thomson power supply 5-2445(white)/5-2446(black)that is
compatible with this unit. Using other adapters may damage the unit.
1
7
3
6