Filter
Top Products
11
Each Line on a Separate Modular Jack
1. Remove the handset hook; turn it
upside down, and put it back in the slot.
You need to do this so the handset
doesn’t fall out of the base.
2. Plug the telephone line cord into the
jack marked L1 and L2 on the back of
the unit and plug the other end into a
modular wall jack.
3. Plug the remaining telephone line cord
into the L2 jack on the back of the unit.
4. Connect the power supply adapter to
the POWER 9V DC jack on the back of
the unit, and then thread it through the
bottom of base.
5. Reverse the direction of the base plate
and replace it by putting the tabs into
the slots on the top of the unit first, and
then by snapping the bottom tabs into
place.
6. Plug the telephone line cord from the
L1 and L2 jack into a single line
modular jack that you want to be line 1.
7. Plug the other telephone line cord into
the single line modular jack you want to
be line 2.
1
2
4
6
7
5
CAUTION: Use only the Thomson power supply 5-2445(white)/5-2446(black)that is
compatible with this unit. Using other adapters may damage the unit.