Filter
Top Products
9
Connections & Set Up
Ringer Type
You may select one of four ringer tones for
incoming calls. The default ringer is type 1.
1. In standby mode, press the MENU/OK button
to go to program setup.
2. Press the or button to move the
pointer to RINGER TYPE.
3. Press the FLASH/EDIT button to select
RINGER TYPE.
4. Press the or button to change the
selection. For example, move the pointer to 4
to select ring type 4. The corresponding ring
tone is generated.
5. Press the MENU/OK button to save the
selected ringer type . You will hear a long
beep, and the display shows SAVED, then
returns to the previous menu.
Hold Reminder Time
You may set the Hold Reminder Time to generate
three short beeps to remind you that a call is on
hold. The default is 30 seconds.
1. In standby mode, press the MENU/OK button.
2. Press the or button to move the arrow
to HOLD REMINDER.
3. Press the FLASH/EDIT button to go to the
programming mode .
4. Press the or button to select the hold
reminder time (Off / 15 / 30 / 45 / 60 sec).
5. Press the MENU/OK button to confirm. You
will hear a long beep and the display shows
SAVED, then returns to the previous menu.
Note: If you choose not to use the HOLD REMINDER
option, press the or button to select OFF.
Flash Time
You may program the FLASH time for your
service need. The default is 600msec.
1. In standby mode, press the MENU/OK button.
2. Press the or button to go to FLASH
TIME. The display shows:
RINGER VOLUME
RINGER TYPE
RINGER TYPE
1
RINGER TYPE
4
RINGER VOLUME
RINGER TYPE
HOLD REMINDER
FLASH TIME
HOLD REMINDER
30 SEC
HOLD REMINDER
OFF
HOLD REMINDER
FLASH TIME