Filter
Top Products
9
MOUNTING THE TAD-724
On a Desktop
1. Plug one end of the supplied mod-
ular cord into the
TEL. LINE
jack
on the back of the TAD.
2. Plug the other end of the supplied
phone cord into a phone jack.
On the Wall
To mount the TAD on a wall plate or
directly on a wall, follow these steps.
Notes:
• To mount the TAD directly on a
wall, you need a drill and two
screws (not supplied) with heads
that fit into the keyhole slots on
the mounting bracket.
• For direct wall mount-
ing you need to drill
two holes 3
15
/16
inches
(100 mm) apart. Then,
thread the screws into
each hole, letting the
heads extend about
1
/4
inch (6.3 mm) from the
wall.
1. Plug one end of the supplied mod-
ular cord into the
TEL. LINE
jack
on the back of the TAD (see illus-
tration in “On a Desktop”).
2. Locate the upper two slots on the
bottom of the TAD and insert the
wall bracket’s matching tabs into
the slots.
3. Carefully press down on the bot-
tom of the bracket until both tabs
on each side of the bracket snap
into place.
4. Route the phone cord into the
right groove on the wall mounting
bracket and route the AC
adapter’s cord into the left groove.
1
/
4
3
15
/
16
43-724A.fm Page 9 Tuesday, May 16, 2000 4:51 PM